# Maximum and minimum number of peers to connect to per torrent.
throttle.min_peers.normal.set = 40
throttle.max_peers.normal.set = 100

# Same as above but for seeding completed torrents (-1 = same as downloading)
throttle.min_peers.seed.set = 25
throttle.max_peers.seed.set = 60

# Maximum number of simultaneous uploads per torrent.
throttle.max_uploads.set = 30

# Global upload and download rate in KiB. "0" for unlimited.
throttle.global_down.max_rate.set_kb = 1024
throttle.global_up.max_rate.set_kb = 50

# Default directory to save the downloaded torrents.
directory.default.set = /mnt/video/rtorrent/downloads

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session.path.set = /mnt/video/rtorrent/.session

# Watch a directory for new torrents, and stop those that have been
# deleted.
schedule2 = watch_directory,5,5,load.start=/home/downloads/~watch/*.torrent

# Close torrents when diskspace is low.
schedule2 = low_diskspace,5,60,close_low_diskspace=10240M

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

# Port range to use for listening.
network.port_range.set = 55956-55956

# Start opening ports at a random position within the port range.
network.port_random.set = no

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
pieces.hash.on_completion.set = yes   

# Set whether the client should try to connect to UDP trackers.
trackers.use_udp.set = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
# 
protocol.encryption.set = allow_incoming,enable_retry,prefer_plaintext

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately). 
# The default is "off". For DHT to work, a session directory must be defined.
# 
dht.mode.set = on

# UDP port to use for DHT.
#
# dht_port = 6881

# Enable peer exchange (for torrents not marked private)
# 
protocol.pex.set = yes

network.scgi.open_port = 127.0.0.1:5050